Sonifex HY-03 Telephone Hybrid
$148.00
$899.94
Sonifex HY-03 Telephone HybridAutomatic Analogue TBU, Free StandingThe analogue HY-03 telephone hybrid is the replacement for the HY-02, which for many years has set the standard as an excellent value, high quality telephone hybrid.The HY-03 retains many o
Sonifex HY-03 Telephone Hybrid
Automatic Analogue TBU, Free Standing
The analogue HY-03 telephone hybrid is the replacement for the HY-02, which for many years has set the standard as an excellent value, high quality telephone hybrid.
The HY-03 retains many of the features of the HY-02 and adds some additional ones. Some of the features of the HY-03 include :
- Fully automatic – adapts to varying line conditions and has automatic signal limiting.
- Local and remote line hold switching – calls can be remotely switched through a mixing console.
- Momentary or permanent latching remotes can be enabled.
- Balanced mic/line input – 10k ohm balanced input selectable for 0dBu clean feed line, or microphone level with adjustable gain.
- Balanced output – 0dBu low impedance balanced output, with output gain adjustment.
- Mixed output – the output can be a mix of the caller and mic/line input signals for recording both sides of the telephone conversation.
- Integrated ring detector – automatic call answering after a pre-determined number of rings.
- Fitted with K-break disconnect detection as standard with an option for dial-tone disconnect using the optional HY-03DTD board. The HY-03DTD board can be configured to disconnect on recognizing the dial tone used in a specific country.
- Line limiter, bandpass filter and output noise gate with preset threshold providing low distortion crystal clear audio.
- 28dB typical line balance rejection.
- Built in power supply with switchable 115V, or 230V, mains input.
- BABT approval compliant with European PTT specifications.
Which Format Is Most Suitable?
The HY-03 analogue hybrids are available in three models :
- HY-03 Single free-standing automatic analogue TBU.
- HY-03S Single 19 rack mounted automatic analogue TBU with ringing detector.
- HY-03T Twin 19 rack mounted automatic analogue TBU.
What The Press Said:
The Guardian, February 2012 >
Technical Specification For HY-03 |
||||||||
Audio Specification |
||||||||
| Input Impedance – Line Mode (Clean Feed): | 10k balanced 0dB | |||||||
| Input Impedance – Microphone Mode: | 2k balanced | |||||||
| Clean Feed Limiting Input: | +4dBu | |||||||
| Microphone Level Range: | From 74dB to 40dB adjusted by preset pot | |||||||
| Bandwidth to Telephone Line: | 250Hz – 4kHz, -3dB ref 1kHz | |||||||
| Telephone Line Impedance: | Nominally 600 | |||||||
| Telephone Line Impedance Range: | 300 to 1500 | |||||||
| Output Impedance: | 50 balanced floating 0dBu | |||||||
| Output Level Range: | +8dB to -14dB adjusted by preset pot | |||||||
| Rejection Ratio: | 45dB on 1kHz tone, typically 28dB on complex waveforms, reference peak level of 0dB | |||||||
| Ring Detector Sensitivity: | 1 ring to 6 rings | |||||||
| Power: | 230V 50Hz, or 115V 60Hz. 6W for HY-03. | |||||||
Connections |
||||||||
| Mic/Line Input: | XLR 3 pin female with push button mic/line selection | |||||||
| Line Output: | XLR 3 pin male | |||||||
| Telephone Line: | RJ11 6/4 socket | |||||||
| Telephone Handset/Instrument: | RJ11 6/4 socket | |||||||
| Remotes: | 9-way D-type socket | |||||||
| Power: | IEC mains (CEE22) | |||||||
| Each unit is supplied with 1 x RJ11 to RJ11 telephone line lead, 1 x RJ11 to BT plug telephone line lead, 1 x BT handset socket to RJ11 plug adapter, IEC mains lead fitted with moulded mains plug, handbook and warranty card. | ||||||||
| Order Code | Description | Height | Width | Depth* | Total Nett Weight |
Total Gross Weight | ||
| HY-03 | Automatic analogue TBU, free standing | 4.5cm 1.8 |
21.8cm 8.6 |
17.5cm 7 |
1.25kg 2.75lbs |
2.0kg 4.4lbs |
||
| HY-03 boxed | 6cm 2.4″ |
34cm 13.4″ |
27cm 10.6″ |
|||||
| *Depth is measured from the front to the end of the connectors fitted to the back of the unit. Note: If you are ordering the HY-03 for use in the USA, add the word US after the product code. If you are using the HY-03 with the Broadcast Bionics PhoneBox system, then add the word BB after the product code. The HY-03 uses different circuitry for these systems. |
||||||||
Accessories |
||||||||
| Order Code | Description | |||||||
| HY-03DTD | Dial tone detect add-on board | |||||||
| HY-03CON | Front panel conversion kit, HY-03S 19 (48cm) rack-mount front to HY-03 free standing | |||||||
| HY-03SCON | Front panel conversion kit, HY-03 free standing to HY-03S 19 (48cm) rack-mount front | |||||||
| HY-03TCON | Front panel conversion kit, HY-03 or HY-03S, to HY-03T 19 (49cm) rack-mount front | |||||||
| HY-02EC | Eurocard version of HY-02 analogue TBU (non RoHS) |
Related products
Kramer Electronics ASPEN-32UFX 32-Port 12G SDI Matrix Switcher
$147.00
$2,916.00
Hawk-Woods VL-190 190Wh 14.4v V-Lok Lithium-Ion Battery
$141.00
$282.00
Samyang VDSLR MK2 3-LENS KIT Sony FE Mount Lenses 14/35/85mm
$149.00
$1,401.60

Reviews
There are no reviews yet.